HOME > Products > Lathes > PC Based CNC Lathes TC-2100 Series

Description:
Descroption \ Model TC-1840/TC-1860/
TC-1880		 TC-2140/TC-2160/
TC-2180		 TC-2540/TC-2560/
TC-2580
Working Capacity
Swing over bed 450mm 540mm 630mm
Center height 225mm 270mm 315mm
Swing over cross slide 220mm 310mm 400mm
Dist. between centers 1000mm 1500mm 2000mm
Width of bed 300mm 350mm 350mm

CNC & Manual operaton
Run first component manually and then the rest automatically
Imperial & metric threading
Easy manual turning of radial, chamfering, taper, facing and grooving
Tool radius & geometry compensation
Three steps speed range and vari-speed in stepless, but H-M-L speed range change which controlled by CNC
Internal digital readout
Constant surface speed for model with infinitive variable speed
Fagor 800TGI or 8055TC
Style 2000TF control
9" VGA high resolution monochrome monitor (14" Opt.)
Integrated PLC
8 bit bus, 32K RAM
Serial port (RS-232 communication)
Teach-in mode
Semiautomatic, automatic(Cycle) and part program modes
Automatic acceleration/deceleration
Rapid travels
Seof diagnostic routines
Automatic home searching
Program input RS-232 or floppy disk (option)
1.44MB floppy disk drive (option)
External DNC communication software (option)

Features & Performance:

All geared headstock provides wide range of spindle speed and the gears are made of chrome-molybdenum alloy steel (SCM 21), Carburizing treated, finish ground for smooth and quiet running, Combined of forced lubrication and oil bathed in headstock which can be prolonged servicing life. Safely designed of electrical cabinet is easy to maintain and install, A 24 volts protecting voltage is not harmed to operator whom is shocked.
Controls of speed change, feed rate and inch/metric thread pitches are arranged for maximum convenience and no need gear changing Especially, the wide range of feed rate selecting and threading are accomplished by turning three levers and one rotary dial. The apron has a interlock device to prevent feeds and thread cutting motion simultaneously and the gears are all oil bathed
The slide way for carriage & saddle are heat treated and precision ground and a hand oiler provides lubricating for longitudinal and cross motion. Rigid constructed tailstock is able to facilitate making precision turning and drilling. Tailstock guill is hardened and precision ground.
Wide bed and box constructed, bed ways are high frequency heat treated, precision ground which can be avoided vibration and tool chattering during made heavy duty processing. The bed and stand are made of one piece Meehanite cast iron which are annealed treatment to eliminate internal residual stress and more stable which can be resisted to vibration due to deep cutting.